WxConfig ADS-WS1 Configuration

Callsign (APRS) Path TX Interval seconds Quiet Time ms Voice ID Comment Position Pick on Map Elevation meters Timezone Select timezone... Comment Interval transmissions (0=never) Power Control Enable power control Delay: seconds Telemetry Send voltage in comments Carrier Detect Any audio Modem carrier detect External - Active High External - Active Low

TX Audio Level (0-255) TX Delay × 10 ms Low-Voltage Inhibit V (0 = disabled) Modem Baud Rate 300 1200

Sensor Sources Indoor Temperature Internal Remote 1-Wire Outdoor Temperature Internal Remote 1-Wire Indoor Humidity Internal Remote 1-Wire Outdoor Humidity Internal Remote 1-Wire Barometer Internal Remote 1-Wire Wind Internal Remote 1-Wire Rain Internal Remote 1-Wire Calibration - Internal Sensors Temperature Offset °F Humidity Offset % Humidity Gain (128 = 1.0×) Barometer Offset ×0.1 mbar Rain Gauge ×0.01 in/tip Anemometer Rate ×0.1 mph/Hz Wind Vane Offset degrees Calibration - External/Remote Sensors Ext. Temp Offset °F Remote Temp Offset °F Remote Baro Offset ×0.1 mbar Remote RH Offset % Remote RH Gain (128 = 1.0×) Display Units Temperature Celsius Fahrenheit Wind Speed MPH KPH m/s Knots Rainfall mm inches Barometer mbar inHg hPa

Enable Transmit when wind conditions change significantly Min Interval seconds between wind-triggered transmits Speed Change MPH change to trigger transmit Direction Change degrees change to trigger transmit Min Wind Speed MPH (ignore changes below this)